Humminbird TCR ID-10 Manuale Utente

OTHER MOUNTING OPTIONS 1. The LCR gimbal bracket can also be mounted on the SM-4, quick disconnect swivel mount. 2. The LCR gimbal bracket can al

It plugs into the outlet on the back of the unit marked “Power”. The transducer connector is identified with the letter T and plugs into the outlet on

Specifications: Operating Frequency 200 KHz Power Requirement 12 volts Power Cable Length 111/2' Transducer (standard) XHS-6-16 high-speed T

NOTE: The built-in simulator will allow you to practice adjusting the sensitivity, but your adjustments will not change readings being displayed on t

60' scale and it changes to the 0-30' scale, the entire screen will look as if you had been in the 0-30' range all along. 2. Using z

Of course, the best way to learn to read your TCR ID-10 is to use it, especially in familiar locations. If you know what's underwater and can

OPERATING THE TCR ID-10 Your new TCR ID-10 offers unique automatic features, as well as many adjustable ones. If you're learning to operate the

The following describes the functions and how to use them, in order of appearance after you turn the unit on. 1. Sensitivity Automatic setting: on

buttons, you can move the zoom window while the zoom is activated, without having to press Select again. 5. Bottom-Lock Automatic setting: off Yo

TRANSDUCER MOUNTING PROCEDURE Humminbird’s high-speed transducer is supplied with your LCR. This transducer has been designed to give good high speed

by rotating up out of the metal spring bracket without harming the transducer, or your boat. The transducer can be re-engaged by simply rotating the t

Once the location is determined mark and drill three 7/64” dia.. holes noted on the template. Attach the metal bracket using three #10 self threadin

NOTE: On boats with more than 15 degree deadrise angle it may be necessary to mount the transducer slightly off parallel with the water level. (See

Step 4 TRANSDUCER ASSEMBLY- Insert the transducer assembly into the metal bracket from the bottom. Push up until the holes in the plastic pivot ali

wrench provided. The screws are visible through the access holes on each side of the metal bracket. Check to make sure the transducer main body is rig

7. Remove the water and transducer and clean the marked area and the bottom of the transducer thoroughly. 8. Using the Humminbird Epoxy Kit or equiv

Install the mounting knobs and tighten snugly. The unit can now be swiveled and tilted to any desired position.